ADJ Products, LLC - www.adj.com - FREQ Matrix Instruction Manual Page 9 ADJ Products, LLC - www.adj.com - FREQ Matrix Instruction Manual Page 10
FREQ Matrix System Menu
SHND: SH 0 - SH 12 - Show modes 0 - 12 & Manual
show. Show mode can run with or without sound active mode
on. Manual show is used in conjunction with knobs located
on the rear of the unit. NOTE: When running the fixture as a
single fixture, it must be set to the Master setting.
See page 15 for Master setting.
1. Press the MENU button until “SHND” is displayed, press
ENTER.
2. “SH X” will now be displayed, “X” representing a number
between 0-12 or “MANU” will be displayed. Shows 1-12 are
preset shows, while “SH 0” is random show. “MANU” is Manual
mode, in this mode you adjust the dimmer and strobe to your
desire using the knobs located on the rear of the unit. Press the
UP or DOWN buttons to nd your desired show.
3. Once you have found your desired show press ENTER, and
then press and hold the MENU button for at least 3 seconds to
conrm.
MANU - In this mode you can manually control the dimmer
and strobe rate. Unlike the Manual show located under the
Show Mode submenu, this Manual mode is NOT USED with
the knobs located on the rear of the unit.
1. Press the MENU button until “MANU” is displayed, press
ENTER.
2. Either “DIMM” or “STRO” will now be displayed. Press the UP
or DOWN buttons to switch between either setting.
3. When you have decided on what setting you would like to
adjust rst, press the ENTER button. Use the UP and DOWN
buttons to make adjustments. Once you have made your desired
adjustments press ENTER.
4. Once you have nished with your adjustments DO NOT leave
this function. If you press the MENU button, all adjustments will
FREQ Matrix System Menu
be lost and you will have to start over.
SOUN - In this submenu you can activate sound active
mode. NOTE: When running the fixture as a single fixture, it
must be set to the Master setting.
See page 15 for Master setting.
1. Press the MENU button until “SOUN” is displayed, press
ENTER.
2. Either “ON” or “OFF” will now be displayed. Press the UP or
DOWN buttons to select one or the other.
3. When you have made your selection, press the ENTER, and
then press and hold the MENU button for at least 3 seconds to
conrm.
SENS - Sound sensitivity control.
1. Press the MENU button until “SENS” is displayed, press ENTER.
2. The display will show a number between 0-100. Press the UP or
DOWN buttons to adjust the sound sensitivity. 0 being the least sensi-
tive and 100 the most sensitive.
3. Press the ENTER, and then press and hold the MENU button for at
least 3 seconds to conrm.
DNST - This mode can be used as a precaution mode, that
in case the DMX signal is lost, the operating mode chosen in
the setup is the running mode the xture will go into when
the DMX signal is lost. You can also set this as the operat-
ing mode you would like the unit to return to when power is
applied.
1. Press the MENU button until “DNST” is displayed, press
ENTER.
2. Either “MASL”, “BLND”, or “LAST” will be displayed. Choose
an operating mode you would like the unit to start up in when
(8 paginas)
(18 paginas)
(16 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales